No Security; Table 20 Wireless: General - ZyXEL Communications P-320W User Manual

P-320W User's Guide
The following table describes the general wireless LAN labels in this screen.

Table 20 Wireless: General

LABEL
Enable
Wireless LAN
Name(SSID)
Hide SSID
Channel
Selection
Apply
Reset
See the rest of this chapter for information on the other labels in this screen.

4.4.1 No Security

Select No Security to allow wireless stations to communicate with the access points without
any data encryption.
Note: If you do not enable any wireless security on your Prestige, your network is
accessible to any wireless networking device that is within range.
64
DESCRIPTION
Click the check box to activate wireless LAN.
(Service Set IDentity) The SSID identifies the Service Set with which a wireless
station is associated. Wireless stations associating to the access point (AP) must
have the same SSID. Enter a descriptive name (up to 32 printable 7-bit ASCII
characters) for the wireless LAN.
Note: If you are configuring the Prestige from a computer connected
to the wireless LAN and you change the Prestige's SSID or
WEP settings, you will lose your wireless connection when you
press Apply to confirm. You must then change the wireless
settings of your computer to match the Prestige's new settings.
Select this check box to hide the SSID in the outgoing beacon frame so a station
cannot obtain the SSID through passive scanning using a site survey tool.
Set the operating frequency/channel depending on your particular region.
Select a channel from the drop-down list box.
Refer to the Connection Wizard chapter for more information on channels.
Click Apply to save your changes back to the Prestige.
Click Reset to reload the previous configuration for this screen.
Chapter 4 Wireless LAN