Back To Factory Defaults; Restart Screen; Figure 96 Configuration Restore Successful; Figure 97 Temporarily Disconnected - ZyXEL Communications P-320W User Manual

P-320W User's Guide
After you see a "Upgrade Successful" screen, you must then wait one minute before logging
into the Prestige again.

Figure 96 Configuration Restore Successful

The Prestige automatically restarts in this time causing a temporary network disconnect. In
some operating systems, you may see the following icon on your desktop.

Figure 97 Temporarily Disconnected

If you uploaded the default configuration file you may need to change the IP address of your
computer to be in the same subnet as that of the default Prestige IP address (192.168.1.1). See
the appendix for details on how to set up your computer's IP address.
If the upload was not successful, the following screen will appear.

Figure 98 Configuration Restore Error

15.2.3 Back to Factory Defaults

Pressing the Restart button in this section clears all user-entered configuration information
and returns the Prestige to its factory defaults.
You can also press the RESET button on the rear panel to reset the factory defaults of your
Prestige. Refer to

15.3 Restart Screen

System restart allows you to reboot the Prestige without turning the power off.
Click the Tools link under Maintenance, and the Restart tab. Click Restart to have the
Prestige reboot. This does not affect the Prestige's configuration.
148
Chapter 2 on page 35 for more information on the RESET button.
Chapter 15 Tools