Lan Screen - ZyXEL Communications NBG-419N User Manual

Chapter 8 Access Point Mode
Table 27 Status Screen: Access Point Mode
LABEL
Rate
Summary
Packet Statistics
WLAN Station Status
8.4.0.1 Navigation Panel
Use the menu in the navigation panel to configure NBG-419N features in Access
Point mode.
The following screen and table show the features you can configure in Access Point
mode.
Figure 46 Menu: Access Point Mode
Refer to Table 26 on page 67
Navigation panel.

8.5 LAN Screen

Use this section to configure your LAN settings while in Access Point mode.
Click Network > LAN to see the screen below.
76
DESCRIPTION
For the LAN ports, this displays the port speed and duplex setting or N/A
when the line is disconnected.
For the WAN port, it displays the port speed and duplex setting if you're
using Ethernet encapsulation and Idle (line (ppp) idle), Dial (starting to
trigger a call) and Drop (dropping a call) if you're using PPPoE or PPTP
encapsulation. This field displays N/A when the line is disconnected.
For the WLAN, it displays the maximum transmission rate when the WLAN
is enabled and N/A when the WLAN is disabled.
Click Details... to go to the Monitor >
(Section 4.5 on page 45). Use this screen to view port status and packet
specific statistics.
Click Details... to go to the Monitor >
(Section 4.6 on page 46). Use this screen to view the wireless stations
that are currently associated to the NBG-419N.
for descriptions of the labels shown in the
Packet Statistics screen
WLAN Station Status screen
NBG-419N User's Guide