ZyXEL Communications NBG-419N User Manual page 209

Table 77 Maintenance > Backup/Restore
LABEL
Upload
Reset
Note: If you uploaded the default configuration file you may need to change the IP
address of your computer to be in the same subnet as that of the default NBG-
419N IP address (192.168.1.1). See
how to set up your computer's IP address.
NBG-419N User's Guide
DESCRIPTION
Click Upload to begin the upload process.
Note: Do not turn off the NBG-419N while configuration file upload is
in progress.
After you see a "configuration upload successful" screen, you must then
wait one minute before logging into the NBG-419N again. The NBG-419N
automatically restarts in this time causing a temporary network
disconnect.
If you see an error screen, click Back to return to the Backup/Restore
screen.
Pressing the Reset button in this section clears all user-entered
configuration information and returns the NBG-419N to its factory
defaults.
You can also press the RESET button on the rear panel to reset the
factory defaults of your NBG-419N. Refer to the chapter about
introducing the Web Configurator for more information on the
RESET button.
Chapter 28 Backup/Restore
Appendix C on page 251 for details on
209