ZyXEL Communications GS 2200 Manual page 78

Chapter 8 Basic Setting
To view the current amount of power that PDs are receiving from the Switch, click Basic Setting >
PoE.
Figure 47 Basic Setting > PoE Status
The following table describes the labels in this screen.
Table 14 Basic Setting > PoE Status
LABEL
PoE Status
PoE Mode
Total Power
Consuming
Power (W)
Allocated Power
(W)
Remaining
Power (W)
Port
State
78
DESCRIPTION
This field displays the power management mode used by the Switch, whether it is in
Classification or Consumption mode.
This field displays the total power the Switch can provide to the connected PoE-enabled
devices on the PoE ports.
This field displays the amount of power the Switch is currently supplying to the connected
PoE-enabled devices.
This field displays the total amount of power the Switch has reserved for PoE after
negotiating with the connected PoE device(s). It shows NA when the Switch is in
Consumption mode.
Consuming Power (W) can be less than or equal but not more than the Allocated
Power (W).
This field displays the amount of power the Switch can still provide for PoE.
Note: The GS2200-24P must have at least 20 W of remaining power in order to supply power
to a PoE device, even if the PoE device needs less than 20 W.
This is the port index number.
This field shows which ports can receive power from the Switch. You can set this in
8.8.1 on page 79.
• Disable - The PD connected to this port cannot get power supply.
• Enable - The PD connected to this port can receive power.
Section
GS2200-8/24 User's Guide