ZyXEL Communications GS 2200 Manual page 200

Chapter 25 IP Source Guard
still available after a restart. To open this screen, click Advanced Application > IP Source Guard
> DHCP Snooping > Configure.
Figure 123 DHCP Snooping Configure
The following table describes the labels in this screen.
Table 70 DHCP Snooping Configure
LABEL
Active
DHCP Vlan
Database
Agent URL
200
DESCRIPTION
Select this to enable DHCP snooping on the Switch. You still have to enable DHCP
snooping on specific VLAN and specify trusted ports.
Note: If DHCP is enabled and there are no trusted ports, DHCP requests will not
succeed.
Select a VLAN ID if you want the Switch to forward DHCP packets to DHCP servers
on a specific VLAN.
Note: You have to enable DHCP snooping on the DHCP VLAN too.
You can enable Option82 in the DHCP Snooping VLAN Configure screen
(Section 25.5.2 on page 203) to help the DHCP servers distinguish between DHCP
requests from different VLAN.
Select Disable if you do not want the Switch to forward DHCP packets to a specific
VLAN.
If Timeout interval is greater than Write delay interval, it is possible that the
next update is scheduled to occur before the current update has finished
successfully or timed out. In this case, the Switch waits to start the next update
until it completes the current one.
Enter the location of the DHCP snooping database. The location should be
expressed like this: tftp://{domain name or IP address}/directory, if
applicable/file name; for example, tftp://192.168.10.1/database.txt.
GS2200-8/24 User's Guide