ZyXEL Communications GS 2200 Manual page 187

Table 63 Advanced Application > AAA > TACACS+ Server Setup (continued)
LABEL
TCP Port
Shared Secret
Delete
Apply
Cancel
Accounting Server
Timeout
Index
IP Address
TCP Port
Shared Secret
Delete
Apply
Cancel
GS2200-8/24 User's Guide
DESCRIPTION
The default port of a TACACS+ server for authentication is 49. You need not change this
value unless your network administrator instructs you to do so.
Specify a password (up to 32 alphanumeric characters) as the key to be shared between
the external TACACS+ server and the Switch. This key is not sent over the network. This
key must be the same on the external TACACS+ server and the Switch.
Check this box if you want to remove an existing TACACS+ server entry from the Switch.
This entry is deleted when you click Apply.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top navigation
panel to save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
Use this section to configure your TACACS+ accounting settings.
Specify the amount of time in seconds that the Switch waits for an accounting request
response from the TACACS+ server.
This is a read-only number representing a TACACS+ accounting server entry.
Enter the IP address of an external TACACS+ accounting server in dotted decimal
notation.
The default port of a TACACS+ accounting server is 49. You need not change this value
unless your network administrator instructs you to do so.
Specify a password (up to 32 alphanumeric characters) as the key to be shared between
the external TACACS+ accounting server and the Switch. This key is not sent over the
network. This key must be the same on the external TACACS+ accounting server and the
Switch.
Check this box if you want to remove an existing TACACS+ accounting server entry from
the Switch. This entry is deleted when you click Apply.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top navigation
panel to save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
Chapter 24 AAA
187