ZyXEL Communications GS 2200 Manual page 144

Chapter 17 Link Aggregation
Make your physical connections - make sure that the ports that you want to belong to the trunk
1
group are connected to the same destination. The following figure shows ports 2-5 on switch A
connected to switch B.
Figure 88 Trunking Example - Physical Connections
A
Configure static trunking - Click Advanced Application > Link Aggregation > Link
2
Aggregation Setting. In this screen activate trunk group T1, select the traffic distribution
algorithm used by this group and select the ports that should belong to this group as shown in the
figure below. Click Apply when you are done.
Figure 89 Trunking Example - Configuration Screen
Your trunk group 1 (T1) configuration is now complete.
144
B
GS2200-8/24 User's Guide