ZyXEL Communications GS 2200 Manual page 267

• A non-administrator (username is something other than admin) is someone who can view but
not configure Switch settings.
Click Management > Access Control > Logins to view the screen as shown next.
Figure 175 Management > Access Control > Logins
The following table describes the labels in this screen.
Table 108 Management > Access Control > Logins
LABEL
Administrator
This is the default administrator account with the "admin" user name. You cannot change the default
administrator user name. Only the administrator has read/write access.
Old Password
New Password
Retype to
confirm
Edit Logins
You may configure passwords for up to four users. These users have read-only access. You can give users
higher privileges via the CLI. For more information on assigning privileges see the CLI Reference Guide.
User Name
Password
Retype to
confirm
Apply
Cancel
GS2200-8/24 User's Guide
DESCRIPTION
Type the existing system password (1234 is the default password when shipped).
Enter your new system password.
Retype your new system password for confirmation
Set a user name (up to 32 ASCII characters long).
Enter your new system password.
Retype your new system password for confirmation
Click Apply to save your changes to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are done
configuring.
Click Cancel to begin configuring this screen afresh.
Chapter 35 Access Control
267