SATO M-8400RVe Operator And Technical Reference Manual page 86

Section 5: Programming Reference
Special Notes
Page 5-20
1. Use of this command will set the Vertical/Horizontal Offset setting
of the printer configuration until a new Base Reference Point
command is issued or the setting is changed from the operator
panel. See Section 3: Configuration.
2. This command may be used more than once in a print job.
3. An alternative to using this command is to make changes to your
current Horizontal and Vertical Print Position commands.
Example:
Let's say the current base reference point is H=1, V=1 and you
wish to move all the fields on your label downward vertically by
150 dots. You could either (1) add the Base Reference Point
command or (2) change all the vertical position commands by an
additional 150 dots.
4. For a more detailed example of the Base Reference Point
command, see "Print Area" in this section.
5. The M-8400RVe will not "wrap" (i.e. if any part of a character or
image extends beyond the last print dot position, it will disappear
and not be visible on any part of the label).
6. The allowable field ranges for this command are:
Horizontal
aaaa
Vertical Default
bbbb
Vertical Expanded
bbbb
PN 9001075A
M-8400RVe
-832 to 832
0001 to 1424
0001 to 9999
SATO M8400RVe