Notes On Remote Control Operation; Available Range Of The Remote Control - Runco CL-420 Owner's Operating Manual

Installation
Notes on Remote Control
Operation
The remote control can be used to control the projector within the ranges shown in Figure
3-1.
Figure 3-1. Available Range of the Remote Control
The signal from the remote control can be reflected by the screen
Note
or other surfaces.
• For best results, hold the remote control within 23 feet (7m) of the back or top sensor
and aligned within 30°.
• Do not drop the remote control or expose it to moisture or high temperature.
• The remote control may malfunction under a fluorescent lamp. If that occurs, move the
projector away from the fluorescent lamp.
• Make sure that there is nothing obstructing the infrared beam between the remote
control and the IR receiver on the projector.
• If the effective range of the remote control decreases, or it stops working, replace the
batteries with new ones.
• Ambient conditions may possibly impede the operation of the remote control. If this
happens, point the remote control at the projector, and repeat the operation.
12 Runco CL-410 and CL-420 Owner's Operating Manual