Installation - Runco CL-420 Owner's Operating Manual

Operation
Source : Component 1
Resolution: 720 x 480
Vert Freq : 60 Hz
Horz Freq : 31 kHz
Lamp Timer : 720 HR
F/W Version : 211 . 3 . 06

Installation

Installation
Language
Picture Configuration Floor Front
OSD Timeout
OSD Transparent
Source Detect
Auto Power Off
Blue Enable
OSD Position
Keystone
Fan High Speed Mode
Information: Select Information from the Main Menu to see information about the current
source, input resolution, horizontal and vertical frequencies, lamp hours and the installed
firmware version.
Should you ever need to contact Runco Technical Support, this information will help them
answer your questions or resolve product performance issues.
Restore Factory Settings: To reset all items in the Image Options menu to their factory
default values, select Restore Factory Settings and press ENTER. A warning message
appears; press ENTER again to confirm the reset or press EXIT to cancel. After the reset,
the projector powers off and restarts.
The Installation menu to change the picture orientation, appearance and behavior of the
OSD menus, fan speed and other projector settings.
Language: Select Language from the Installation menu and press the right- or left-arrow
English
buttons to select the OSD language (English, French, Italian, German or Spanish).
5 secs Picture Configuration: Select Picture Configuration from the Installation menu to
change the picture orientation to suit the method of installation (Floor Front, Floor Rear,
OFF
Ceiling Front or Ceiling Rear).
Auto
OFF
OSD Timeout: The OSD Timeout setting controls how long the OSD menus stay on
OFF
screen when no buttons are pressed. Select a time-out period of 5, 15 or 60 seconds.
OSD Transparent: To allow the projected image to show through the OSD menus,
select OSD Transparent from the Installation menu and set it to ON.
ON
Source Detect: The CL-410/CL-420 can automatically detect an incoming signal and
switch to that input. To enable automatic source detection, select Source Detect from the
Installation menu and set it to Auto.
Auto Power Off: The CL-410/CL-420 can be set to power off automatically after 15
minutes of no input signal or user input via the remote control. To enable this feature, set it
to ON. When you do, a warning message appears on-screen five minutes before the
shutdown is to occur. To prevent the projector from powering off, press any key on the
remote control.
Blue Enable: Blue Enable removes all red and green color information from the image,
simulating a blue filter. You can use it instead of a blue filter when performing color and tint
adjustments.
OSD Position: To change the position of the OSD controls, select OSD Position from the
Installation menu. Use the up- and down-arrow buttons to select Top Left, Bottom Left,
Top Right or Bottom Right, then press ENTER.
42 Runco CL-410 and CL-420 Owner's Operating Manual