Tcp/Ip; Installation Procedure - Ricoh Aficio BP20 User Manual

TCP/IP

Use these instructions to install the device on a TCP/IP network using Web Aficio BP20N.

Installation Procedure

There are two stages required to install the device on a TCP/IP network using Web Aficio
BP20N:
Configure the Aficio BP20N
Test Print
Configure the Aficio BP20N
NOTE: The TCP/IP settings for the device will have been set up when completing
the Enabling Web Aficio BP20N section.
To complete the installation of the device, perform these steps:
1 Enable Web Aficio BP20N (see "Enabling Internet Services" on page 3-5).
2 At the Web Aficio BP20N Home Page for the Aficio BP20N, select the [Network
Administrator] tab.
3 Click TCP/IP menu in the left frame.
Check if the TCP/IP Configuration details are correct. If any of the details are incorrect
4
then enter the correct information.
NOTE: DHCP automatically assigns IP addresses and is the default setting. If the
IP Address needs to be edited but is unavailable, select IP Address Assignment
Method and then Static to continue.
Administratior Guide
This procedure explains how to use Web
device.
A print job should be submitted to ensure the device has been installed and
configured correctly.
Choose the [IP Address Assignment Method] required.
Enter the [IP Address].
to configure the
Aficio BP20N
Page 3-7