Windows Configuration; Configuring Tcp/Ip; Configuring A Windows 95/98/Me Computer; Configuring A Windows 2000 Computer - Ricoh Aficio 2105 Network Manual

4. Windows Configuration

Configuring TCP/IP

Follow these instructions to configure
Windows to use TCP/IP and IPP.
Configuring a Windows
95/98/Me computer
These steps are for configuring a Win-
dows 95/98/Me computer to use
TCP/IP.
A A A A
Open [Control Panel], and then
double-click the [Network] icon.
Make sure that TCP/IP is listed in
the [The following network compo-
nents are installed] box on the [Con-
figuration] tab.
Note
❒ Under Windows Me, if you
want to use IEEE 1394 (IP over
1394) interface, make sure TCP/
IP is bound to the IEEE 1394
adaptor being used. The follow-
ing message will be displayed:
TCP/ IP -> (IEEE 1394
adaptor in use)
❒ If TCP/IP is not installed, click
[Add] on the [Configuration] tab to
install it. For more information
about installing TCP/IP, see
Windows 95/98/Me Help.
B B B B
Configure TCP/IP with the appro-
priate IP address, subnet mask
and other settings.
Check with the network adminis-
trator that the settings are correct.
Configuring a Windows 2000
computer
These steps are for configuring a Win-
dows 2000 computer to use TCP/IP.
A A A A
Click the[Start]button on the task-
bar, point to [Settings], and then
click [Network and Dial-up Connec-
tions].
B B B B
Double-click [Local Area Connec-
tion]. On the [General] tab, click
[Properties].
C C C C
Make sure that Internet Protocol
(TCP/IP) is selected in the [Compo-
nents checked are used by this connec-
tion] box on the [General] tab.
Note
❒ Select TCP/IP if it is not already
selected.
❒ If TCP/IP is not installed, click
[Install] on the [General] tab to in-
stall it. For more information
about installing TCP/IP, see
Windows 2000 Help.
D D D D
Configure TCP/IP with the appro-
priate IP address, subnet mask
and other settings.
Check with the network adminis-
trator that the settings are correct.
27