Connection And Recognition - Panasonic HDC-SD100 Operating Instructions Manual

2
Setup
After the software applications are installed, this unit must be connected to the PC and be correctly
recognised by the PC.
Remove the supplied CD-ROM from your PC.
USB cable (supplied)
1
Connect this unit to the AC
adaptor.
2
Turn on the unit.
This function is available in all modes.
3
Connect this unit to a PC.
The USB function selection screen will appear.
Insert the USB connectors as far as they will go.
Do not use any other USB connection cables
except the supplied one. (Operation is not
guaranteed with any other USB cables.)
4
Select [PC CONNECT] and press
the cursor button.
This unit is automatically detected by the PC.
[AVCHD CONNECT] is for future expansion menu.
When the unit is connected to a PC, the
operation mode cannot be changed and its
power cannot be turned off.

Connection and recognition

Disconnect the USB cable, before turning
this unit off.
Do not disconnect the USB cable or the AC
adaptor while the card access lamp is on or
card access icon (
screen. Doing so may damage the data.
Use the following methods to enable it to be
recognised.
Method 1:
Turn off the unit and your PC once and try
verifying again.
Method 2:
Remove the SD card and try verifying again.
Method 3:
Try connecting the unit to another USB port on
your PC.
1
Depending on your PC's settings, this icon
may not be displayed.
2
3
) appears on the unit
If the driver has not been
recognised properly
To disconnect USB cable safely
Double click the (
tray displayed on the PC.
Select [USB Mass Storage Device] and
click [Stop].
Verify [MATSHITA HDC-SD100/SD USB
Device] is selected and click [OK].
) icon in task
111
VQT1T90