Connection And Recognition; Connection And Recognition Procedures - Panasonic HDC-SD1 Operating Instructions Manual

With a computer

Connection and recognition

Connection and recognition
procedures
After the software applications are installed, this
unit must be connected to the computer and be
correctly recognised by the computer.
≥Connect after installing the software
applications.
≥Remove the supplied CD-ROM if it is inserted
in the computer. (If the [Setup Menu] screen is
displayed, wait until it finishes and then remove
the CD-ROM.)
≥If the recognition procedure is not
accomplished properly, operation will not be
possible after connecting the unit to the
computer.
≥If the unit fails to operate normally, it may mean
that you have not conducted the installation or
recognition procedure properly.
1
Insert the battery and connect
the AC adaptor.
≥If you do not insert the battery and connect
the AC adaptor, operation will not be
possible after connecting this unit to the
computer.
2
Insert an SD card with recorded
images in this unit and then set
the mode dial to
the power.
94
VQT1A34
3
A USB cable (supplied)
This unit is automatically recognised by the
computer.
≥Insert the plugs as far as they will go. The unit
≥Do not use any other USB connection cables
≥When the unit is connected to a computer,
≥When a computer is accessing the SD card in
to turn on
≥It may be necessary to reboot the computer
Connect this unit and a
computer.
and computer will not operate properly if the
plugs are not inserted fully.
except the supplied one. (Operation is not
guaranteed with any other USB cables.)
the operation mode cannot be changed and
its power cannot be turned off.
In this case, disconnect the USB cable (l 96).
this unit, the card access lamp lights. (When a
card is being accessed,
LCD monitor.) Do not disconnect the USB
cable or AC adaptor while the card is being
accessed as it may damage the data.
after connecting this unit to it for the first time.
A
appears on the