Panasonic HDC-SD100 Operating Instructions Manual page 124

Problem
This unit cannot be
operated though it is
turned on.
This unit does not
operate normally.
The remote control does
not function.
The remaining time
indication or the elapsed
time indication is not
shown.
Recording does not start
although power is
supplied to this unit and
the SD card is correctly
inserted.
The unit arbitrarily stops
recording.
Auto focus function does
not work.
Colour balance of images
is strange when
recording in a place such
as a gymnasium.
124
VQT1T90
Check points
p The unit will not operate unless the LCD monitor is opened
when the LCD/EVF select switch is set to LCD.
p Turn on the power again. If normal conditions are not
restored yet, remove the battery or AC adaptor, wait about
1 minute and then reconnect the battery or AC adaptor.
Then about 1 minute later, turn on the power again.
(Conducting the above operation while the SD card is being
accessed may damage the data on the SD card.)
p The button-type battery of the remote control may be run
out. Replace it with a new button-type battery. (F 14)
p If you set [SETUP]  [DISPLAY]  [OFF], indications
other than warnings and date etc. are not displayed. (F 24)
p Rotate the mode dial to select
p No recording is possible while the SD card's write protect
switch is set to LOCK. (F 19)
p If there is no more available memory of the SD card, free up
some memory by deleting unnecessary scenes or use a
new SD card. (F 20, 78)
p If the SD card cover is open, this unit may not operate
normally. Close the SD card cover.
p Use an SD card that can be used for motion picture
recording. (F 19)
p If [AGS] is [ON], record in the normal horizontal position or
set [AGS] to [OFF]. (F 33)
p Set the AUTO/MANUAL switch to AUTO.
p If you are trying to record a scene which is hard to bring into
focus in auto focus mode, use the manual focus mode to
adjust the focus. (F 65, 135)
p In a place with multiple light sources, such as a gymnasium
or a hall, the auto white balance function may not operate
properly. In this case, set the white balance setting to [
(Indoor mode2)]. If you cannot record clearly with the [
(Indoor mode2)], set it to [
(F 66)
.
(Manual adjustment mode)].