Installing The Driver; Installing The Driver In A New Windows System - MSI MS-9246 User Manual

MS-9246 1U Rackmount Server
This section describes installing the driver and setting up the new array for the drives
attached to your controller. Before you get started, you need to select from the
following scenarios for installing the controller driver on W indows or Linux systems:

Installing the Driver in a New Windows System

Installing the Driver in an Existing Windows System
Installing Red Hat Linux 7.3 or 8.0
Installing SuSE Linux 8.0 or 8.1
1. Installing the Driver in a New Windows System
In this scenario, you are installing the driver in a new system that has no operat-
ing system. To install the driver:
1. Create a driver disk by following the instructions from the Web site or the
product CD.
2. Restart the computer.
3. If creating an array, press Ctrl-A when prompted to enter the ARC utility.
For instructions on creating an array from the BIOS, see Adaptec RAID
Configuration Utility. For a simple volume, skip to Step 4.
4. W hen the array is finished building or if you are continuing from Step 3,
insert the W indows setup CD and restart the system.
5. Press F6 when prompted to install a third-party driver.
MSI Reminds You...
When F6 is active, a prompt appears at the bottom of the screen. Press
F6 immediately — you only have 5 seconds. If you miss your chance,
restart this Windows installation to complete it correctly. Otherwise,
Windows will not recognize your controller.
6. Insert the driver disk you created in Step 1 and wait until prompted to install
a driver.
7. Press S to specify that the driver is on the floppy disk, and press Enter.
W indows searches the disk for a suitable driver.
8. W hen the Adaptec Embedded Serial ATA HostRAID driver is found, press
Enter. Follow the remaining on-screen instructions to complete your
installation.
B-4

Installing the Driver