Table of Contents
Advertisement
Send Start Unit Command
W hen set to Yes, the SCSI controller sends the Start Unit command to the
specified SCSI device during bootup. The interface powers up the SCSI device
on-at-a-time during bootup, reducing the load on the computer's power supply.
Setting options: [Yes], [No].
BIOS Multiple LUN Support
Select [Yes] when any SCSI device has multiple logical units. Setting options:
[Yes], [No].
Include in BIOS Scan
Selecting [Yes] allows the SCSI controller to control the SCSI device with its
SCSI ID. W hen set to [No], the SCSI controller does not control the specified
SCSI device by not scanning for the SCSI ID during bootup, but the boot time will
be decreased. Setting options: [Yes], [No].
Advanced Configuration
Press <Enter> to enter the sub-menu screen for advanced configuration.
Reset SCSI Bus at IC Initialization ...................................................... Enabled
Display <Ctrl><A> Message During BIOS Initialization ............. Enabled
Extended Int 13 Translation for DOS Drives > 1 GByte ................ Enabled
POST Display Mode ............................................................................... Verbose
SCSI Controller Int 13 Support ............................................................ Enabled
Option Listed Below Has NO EFFECT if MULTI LUN Support is Disabled
Domain Validation ................................................................................. Enabled
Support Removable Disks Under Int 13 as Fixed Disks ................ Disabled
BIOS Support for Bootable CD-ROM ................................................. Enabled
Reset SCSI Bus at IC Initialization
Selecting [Enabled] will reset the SCSI bus the first time the SCSI controller is
initialized. Setting options: [Enabled], [Disabled].
Display <Ctrl><A> Message During BIOS Initialization
W hen enabled, the message "Press <Ctrl><A> for SCSISelect(TM) Utility" ap-
pears on the screen during bootup. If disabled, the message does not show up,
but you can still press <Ctrl> + <A> key combination to enter the SCSI BIOS
utility. Setting options: [Enabled], [Disabled].
Extended Int 13 Translation for DOS Drives > 1 GByte
The field allows SCSI hard disk drives greater than 1 GB to use a translation
scheme of 255 heads, 63 sectors per track. Setting options: [Enabled], [Disabled].
Advanced Configuration
SCSI BIOS Setup
A-7
Advertisement
Table of Contents
