Table of Contents
Advertisement
MS-9246 1U Rackmount Server
Configure/View SCSI Controller Settings
There are 8 items in the "Configure/View SCSI Controller Settings" screen. These
items display or allow you to change the SCSI controller's settings. Use the arrow
keys to highlight the item and then press <Enter> to select the value you want in each
item or enter each item's sub-menu screen.
Options
SCSI Bus Interface Definitions
SCSI Controller ID ..................................... 7
SCSI Controller Parity ............................... Enabled
SCSI Controller Termination .................... Enabled
Additional Options
Boot Device Configuration ........................ Press <Enter>
SCSI Device Configuration ....................... Press <Enter>
Advanced Configuration ............................ Press <Enter>
BIOS Information
Interrupt (IRQ) Channel ............................. 11
I/O Port Address ......................................... B000h, B400h
SCSI Controller ID
The item is used to assign a SCSI ID to the SCSI controller. It is recommended that you
should leave the default setting unchanged. Settings: [0]~[15].
SCSI Controller Parity
Use the field to enable or disable SCSI parity error checking function. If any of your
SCSI devices does not support parity checking, disable this function. W hile disabling
the function, you should disable disconnections for all devices, as parity checking for
the reselection phase is NOT disabled. A non-parity device's I/O operation will never
complete if the reselection fails due to a parity error.
SCSI Controller Termination
In order to have the SCSI bus function properly and reliably, termination at the ends of
A-4
AIC-7902 A at slot 0A, 03:07:00
<F6> -- Reset to SCSI Controller Defaults
SCSI Bus Interface Definitions
Advertisement
Table of Contents
