MSI MS-7160 User Manual page 21

M S-7160 ATX M ainboard
11. Visually inspect if the CPU is seated
well into the socket, then remove the
CPU Clip with 2 fingers. Then cover
the load plate back to the place.
13. Align the holes on the mainboard with
the cooler. Push down the cooler until
its four c lips get wedged into the
holes of the mainboard.
15. Turn over the mainboard to confirm
that th e c li p-en ds are c orrec tly
inserted.
MSI Reminds You...
1. Check the information in PC Health Status in BIOS (Chapter 3) for
the CPU temperature.
2. Whenever CPU is not installed, always protect your CPU socket pin
with the plastic cap covered (shown in step 5) to avoid damaging.
3. Please note that the mating/unmating durability of the CPU is 20 cycles.
Therefore we suggest you do not plug/unplug the CPU too often.
E-2-6
12. Press down the load lever lightly
onto the load plate, and then secure
the lever with the hook under reten-
tion tab.
14. Press the four hooks down to fasten
the cooler. Then rotate the locking
switch (refer to the correct direction
marked on it) to lock the hooks.
locking
switch
Note: If you want to uninstall the CPU,
align the 4 points (see Setp 8 for
details) again and push the clip to
lift up the CPU.