Changing The Interface Parameters - Kyocera Mita Ecosys FS-1800+ Operation Manual

Using the Operator Panel

Changing the Interface Parameters

Interface
Parallel
MENU
ENTER
ENTER
The printer is equipped with both a parallel and serial interface. Option
>
network interface card can also be installed. Various printing environment
parameters such as the default emulation can be changed indepently on
different interfaces by using the printer's menu selection system. Before
select the interface to apply the changes in the procedure described below.
This interface selection described below does not select which interface
data will be received from. The printer automatically selects an interface
data is received.
Note
Changing Parallel Interface Modes
The parallel interface mode of this printer supports a bi-directional/high-
speed mode. Normally, this interface is used under the default setting
AUTO. For details, see
reset the printer or turn the power off at least once. The new setting will be
enabled thereafter.
1
Press the MENU key.
2
Press the
of the interface names shown below appears, indicating the current
interface.
Parallel (default)
Serial
Option (when a network interface card is installed)
3
Press the ENTER key. A blinking question mark (?) appears.
Interface
? Parallel
If Parallel is not displayed, press the
it is Parallel.
If you want to abandon the interface selection procedure, press the
CANCEL key. The interface remains unchanged.
4
Press the ENTER key again.
Appendix C. After setting the interface, be sure to
or key repeatedly until Interface > appears. One
1-40
or key repeatedly until