Kyocera Mita Ecosys FS-1800+ Operation Manual page 134

Using the Operator Panel
>Sleep Timer
MENU
?
ENTER
ENTER
MENU
Sleep Timer Setting
>
The printer has a sleep timer to conserve power when the printer is not
printing, processing, or receiving data. You can adjust the timer value, the
length of time the printer waits before entering sleeping mode in the
absence of data.
1
Press the MENU key.
2
Press the
Others
3
Press the > key.
4
Press the
The default setting is 015 min.
>Sleep Timer
5
Press the ENTER key. A blinking cursor ( _ ) appears.
>Sleep Timer
6
Press the
where the cursor is blinking and set the desired time. The timer can
be set between 5 and 240 min, in 5-minute increments. You can use
the > and < keys to move the cursor right and left.
If you want to abandon the setting procedure, press the CANCEL
key.
7
Press the ENTER key.
8
Press the MENU key. The message display returns to Ready.
or key repeatedly until Others > appears.
>
or key repeatedly until >Sleep Timer > appears.
>
015 min.
015 min.
or key to increase or decrease the value of the figure
1-122