Expanding The Printer Memory - Kyocera Mita Ecosys FS-1800+ Operation Manual

Expanding the Printer Memory

B.1 Expanding the Printer Memory
This section explains how to expand the printer's memory. Expanded
printer memory enables you to print more complex pages, download more
fonts, and define more macros.
This section first explains how to remove the main circuit board and then
how to install a DIMM (Dual In-line Memory Module) on the main circuit
board.
This printer comes supplied with 8 MB of memory installed. Two sockets
are provided for expanding the printer memory to allow more complex
printing jobs and increase the printing speed. By installing DIMMs into
your printer, the memory in the printer can be increased to a maximum of
264 MB.
The expansion memory should be installed only by a Kyocera Mita
authorized dealer or Kyocera Mita certified technician. Kyocera Mita shall
not be liable for damage due to improper installation of the expansion
Note
memory.
The minimum memory requirements for the printer with various options
installed are listed in the table below. Please refer to this table when
expanding the printer's memory.
Printing condition
PCL 6, duplex mode = None
PCL 6, duplex mode = On
KPDL, duplex mode = None
KPDL, duplex mode = On
PCL 6/KPDL resource
protection,
duplex mode = None
PCL 6/KPDL, resource
protection,
duplex mode = On
300 dpi 600 dpi
8 MB 8 MB
8 MB 8 MB
8 MB 8 MB
8 MB 8 MB
– 16 MB
– 16 MB
B-2
Resolution
1200 dpi
Fast 1200 Fine 1200
mode mode
8 MB 8 MB
8 MB 16 MB
8 MB 8 MB
16 MB 16 MB
16 MB 16 MB
16 MB 16 MB