Setting Cutting Depth - Grizzly T33300 Owner's Manual

2. Loosen riving knife lock screw and position
riving knife ⁄ "– ⁄ " (2–3mm) away from saw
3 1
32 8
blade teeth just above lowest part of blade
(see Figure 10).
2–3mm
Riving Knife
Figure 10. Positioning riving knife with blade.
3.
Tighten riving knife lock after adjustment.
4. Use straightedge to verify riving knife is prop-
erly aligned with blade.
— If riving knife and saw blade are mis-
aligned, verify blade thickness is not less
than thickness of riving knife.
— If thickness is correct, remove riving knife
and check for straightness.
IMPORTANT: NEVER use warped or dam-
aged riving knife when making a cut or kick-
back may occur.
Model T33300 (Mfd. Since 04/22)
Cutting depth should always be set just past the
bottom of the workpiece. To accurately set the
depth, position the saw along one edge of the
workpiece so that the blade extends below the
workpiece. Once the blade is extended, deter-
mine the necessary depth by allowing the blade
to extend roughly
workpiece (see Figure 11).
Saw Blade
To set cutting depth:
1.
2.
Setting Cutting
Depth
⁄ " beyond the bottom of the
1
8
Figure 11. Setting saw depth.
Loosen lock knob and adjust depth stop
along scale to maximum depth desired for cut
(see Figure 12).
Depth
Scale
Figure 12. Depth-setting components.
Secure lock knob.
Note: Cutting depth shown on scale is the
depth WITHOUT the optional guide rail. Rail
adds an additional ⁄
3
16
⁄ " Blade
1
8
Clearance
Depth Stop
Lock Knob
" to cutting point.
-19-