Ppp Logs - NETGEAR FVX538 - ProSafe VPN Firewall 200 Router Reference Manual

ProSafe VPN Firewall 200 FVX538 Reference Manual

PPP Logs

This section describes the WAN PPP connection logs. The PPP type can be configured from the
web management.
PPPoE Idle-Timeout Logs.
Table C-9. System Logs: WAN Status, PPE, PPPoE Idle-Timeout
Message
Explanation
Recommended Action
C-6
Nov 29 13:12:46 [FVX538] [pppd] Starting connection
Nov 29 13:12:49 [FVX538] [pppd] Remote message: Success
Nov 29 13:12:49 [FVX538] [pppd] PAP authentication succeeded
Nov 29 13:12:49 [FVX538] [pppd] local IP address 50.0.0.62
Nov 29 13:12:49 [FVX538] [pppd] remote IP address 50.0.0.1
Nov 29 13:12:49 [FVX538] [pppd] primary DNS address 202.153.32.3
Nov 29 13:12:49 [FVX538] [pppd] secondary DNS address 202.153.32.3
Nov 29 11:29:26 [FVX538] [pppd] Terminating connection due to lack of activity.
Nov 29 11:29:28 [FVX538] [pppd] Connect time 8.2 minutes.
Nov 29 11:29:28 [FVX538] [pppd] Sent 1408 bytes, received 0 bytes.
Nov 29 11:29:29 [FVX538] [pppd] Connection terminated.
Message 1: PPPoE connection establishment started.
Message 2: Message from PPPoE server for correct login
Message 3: Authentication for PPP succeeded.
Message 4: Local IP address assigned by the server.
Message 5: Server side IP address.
Message 6: primary DNS configured in WAN status page.
Message 7: secondary DNS configured in WAN status page.
Message 8: The PPP link has transitioned to idle mode. This event occurs if
there is no traffic from the LAN network.
Message 9: The time in minutes for which the link has been up.
Message 10: Data sent and received at the LAN side during the link was up.
Message 11: PPP connection terminated after idle timeout
To reconnect during idle mode, initiate traffic from the LAN side.
v1.0, March 2009
System Logs and Error Messages