NETGEAR FVX538 - ProSafe VPN Firewall 200 Router Reference Manual page 138

ProSafe VPN Firewall 200 FVX538 Reference Manual
b. From the ID Type pull-down menu, select IP Subnet.
c. Enter the IP Subnet and Mask of the VPN firewall (this is the LAN network IP address of
the gateway).
d. Check the Connect using radio button and select Secure Gateway Tunnel from the pull-
down menu.
e. From the ID Type pull-down menu, select Domain name and enter the FQDN of the VPN
firewall; in this example it is "local_id.com".
f. Select Gateway IP Address from the second pull-down menu and enter the WAN IP
address of the VPN firewall; in this example it is "172.21.4.1".
Figure 5-27
2. From the left side of the menu, click My Identity and enter the following information:
a. Click Pre-Shared Key and enter the key you configured in the FVX538 IKE menu.
b. From the Select Certificate pull-down menu, select None.
c. From the ID Type pull-down menu, select Domain Name and create an identifier based on
the name of the IKE policy you created; for example "remote_id.com".
5-34
v1.0, March 2009
Virtual Private Networking