NETGEAR FVX538 - ProSafe VPN Firewall 200 Router Reference Manual page 47

1. Select Network Configuration from the primary menu and LAN Setup from the submenu.
The LAN Setup screen will display.
Figure 3-1
2. Enter the IP Address of your router (factory default: 192.168.1.1). (Always make sure that the
LAN Port IP address and DMZ port IP address are in different subnets.)
3. Enter the IP Subnet Mask. The subnet mask specifies the network number portion of an IP
address. Your router will automatically calculate the subnet mask based on the IP address that
you assign. Unless you are implementing subnetting, use 255.255.255.0 as the subnet mask
(computed by the router).
4. Check the Enable DHCP Server radio button. By default, the router will function as a DHCP
(Dynamic Host Configuration Protocol) server, providing TCP/IP configuration for all
computers connected to the router's LAN. If another device on your network will be the DHCP
server, or if you will manually configure all devices, check the Disable DHCP Server radio
button. Enable DHCP Server is the default. If Enabled is selected, enter the following
parameters:
a. Enter the Domain Name of the router (this is optional).
LAN Configuration
ProSafe VPN Firewall 200 FVX538 Reference Manual
v1.0, March 2009
3-3