Video Resolutions Table - JBL AV2 User Manual

Performance series audio/video processor
Table of Contents

Advertisement

Troubleshooting and Maintenance

VIDEO RESOLUTIONS TABLE

The AV2 processor is designed to allow flexibility in the selection of
video output resolutions. However, there are restrictions on what
resolutions can be made available due to incoming signal
limitations.
If you are not getting the expected resolution options for your
video monitor, it is possible that there is an incompatability
between the input setup selections and the incoming signal. The
table below describes those formats that are possible, given a
specific input source and input setup conditions.
Notes:
The following notes refer to the "Note" column in the table.
1. If the incoming HDMI signal is copy-protected (HDCP), all
analog video output is blocked. All the available outputs that
may be affected by copy protection are noted in the table by a
double asterix (**).
INPUT
Source
Format
480i
480p
HDMI
720p
1080i
480i
480p
Component
Analog
720p
1080i
S-480i
S-Video,
Composite
C-480i
Analog
SandC - 480i
6-10
Video Mode
HDMI
480p ~ 1080i
480p ~ 1080i
720p ~ 1080i
1080i
480p ~ 1080i
FAROUDJA ON
480p ~ 1080i
720p ~ 1080i
1080i
480p ~ 1080i
480p ~ 1080i
720p ~ 1080i
2. If the incoming analog video signal is Macrovision® protected, a
form of copy protection for analog sources, then the component
video output must be either 480i or 480p resolution. If the
output resolution setting has a value that is higher than 480p
resolution, then no analog signal is output.
3. If HDMI is not connected when the incoming signal is
Macrovision-protected analog video, then the VIDEO OUT
parameter changes automatically to 480p resolution and only
component video is output.
4. The difference between BYPASS and CONVERSION options is
where the video encoder is used (CONVERSION) or not
(BYPASS) when the S-video or composite video input is selected.
In CONVERSION mode, digital video from the analog input is
provided to the video encoder and the S-video and composite
video outputs are encoded. In BYPASS mode, the analog input
signal goes to the video output directly, with no encoding.
OUTPUT
Component
S-Video
480p ~ 1080i**
480i**
480p ~ 1080i**
-
720p ~ 1080i**
-
1080i**
-
480p ~ 1080i
480i
480p ~ 1080i**
-
720p ~ 1080i**
-
1080i
-
480p ~ 1080i**
480i (from S)
480p ~ 1080i**
480i (from C)
720p ~ 1080i
480i (from S)
Harman Consumer Group, Inc.
Composite
Note
480i**
1
-
1
-
1
-
1
480i
2, 3
-
2, 3
-
2, 3
-
2, 3
480i (from S)
2, 3
480i (from C)
2, 3
480i (from S)
2, 3

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Performance series

Table of Contents