Display Setup - JBL AV2 User Manual

®
JBL Performance™ Series AV2 Audio/Video Processor

DISPLAY SETUP

Selecting the SETUP menu, DISPLAY SETUP option opens the DISPLAY SETUP menu, which is used to customize the OSD and front panel display
and set up other display-related features.
MAIN MENU
AUDIO CONTROLS
VIDEO CONTROLS
SETUP
CONNECTION
CONNECTION

DISPLAY SETUP

SETUP
Selects the CONNECTION parameter, which identifies the active
video output connectors on the AV2 rear panel. The following list of
conditions identify the behavior of this parameter:
• If ANALOG is selected, only the analog video connectors are
available and will output the video signal.
• If HDMI/DVI is selected, both the analog and HDMI video
connectors are available and will output the video signal.
• If the video input is set to HDMI and the CONNECTION
parameter is set to ANALOG, then no video is output.
• If the HDMI video input is copy-protected (HDCP), no video is
output on the analog output connectors. This is a requirement
of HDCP and not a limitation of the AV2 processor.
SETUP
DISPLAY SETUP
DISPLAY SETUP
CONNECTION: HDMI/DVI
SPEAKER/EQ SETUP
HDMI AUDIO OUT: NO
INPUT SETUP
ON-SCREEN DISPLAY
SURROUND CONFIG
FRONT PANEL DISPLAY
DOLBY CONFIG
MUTE LEVELS
POWER ON SETTINGS
BASSQ*: NO
*CHECK MANUAL FIRST
HDMI AUDIO OUT
ANALOG, HDMI/DVI
Selects the HDMI AUDIO OUT parameter, which identifies if audio is
sent on the HDMI output. If the HDMI AUDIO OUT parameter is set
to YES, then a two-channel DOWN MIX of the source audio is sent
over the HDMI connection at the maximum bit rate of the display's
audio system. This audio stream is in addition to the normal audio
outputs. If the parameter is set to NO, this audio is not sent.
ON-SCREEN DISPLAY
two-line OSD: 3s
MENU TIME OUT: 30s
FRONT PANEL DISPLAY
BRIGHTNESS: FULL
TIME OUT: NONE
HDMI AUDIO OUT
SETUP DISPLAY SETUP
Setup
YES, NO
3-3