Docking The Ipod; Dock Two-Line Display Characteristics; Dock Two-Line Display Characteristics - JBL AV2 User Manual

®
JBL Performance™ Series AV2 Audio/Video Processor
To remove the factory-installed
insert, hold the dock with one
hand as you grab the edges of
the insert in the dock with your
other hand, then pull straight
up. Use the following as a
guide to determine which
insert is correct for your iPod model:
• For the iPod Nano Video 3rd generation 4GB/8GB model, use
the insert marked "13" on the back.
Note: This is the insert that was installed into the dock at the
factory.
• For the iPod Nano 1st and 2nd generation models, use the
insert marked "NANO" on the back.
• For the iPod Video 5th generation 60GB/80GB or iPod Classic
160GB models, use the insert marked "5G VIDEO 60GB" on
the back.
• For the iPod Video 5th generation 30GB, iPod U2 30GB, or
iPod Classic 80GB models, use the insert marked "5G VIDEO
30GB" on the back.
• For the iPhone 4GB/8GB or iPod Touch 8GB/16GB models, use
the insert marked "12 14" on the back.
Note: Two black curved rubber parts are included with this
adaptor. Attach the thin one if you are using an iPhone or use the
thicker one if you are using an iPod Touch.
Once you have selected the correct insert, place it over the well in
the center of the dock and gently press it down so that it snaps into
place.
Note: Do not place an iPod in the dock unless an insert is installed; otherwise
the iPod can't connect properly and damage may occur to the dock and/or
your iPod that is not covered by the warranty for either product.

DOCKING THE iPod

After placing the appropriate insert in the
center well of the dock and connecting
the dock to your receiver, dock your iPod
by placing it into the insert, gently
pressing it down until the connectors
mate between the iPod and the dock.
Note: If you normally keep your iPod in a
protective case, or "skin", you will need to
remove it before docking your iPod.
When the iPod is plugged into the dock, the iPod navigation
controls are no longer accessible and the iPod screen will read "OK
to disconnect".

DOCK TWO-LINE DISPLAY CHARACTERISTICS

When the Dock input is selected, the two-line front panel display
changes so that the left side of the display reflects the current iPod
information. Initially, the two-line display on the AV2 displays
"Menu" on the left side of the top line. "Playlists" and the number
of playlists available are displayed on the left side of the bottom
line. The ANLG signal type is identified on the top right side, and
the current volume setting of the AV2 is identified on the bottom
right side of the display, as shown:
MENU
PLAYLISTS 11
Note: The name of the iPod is always included as the first playlist.
PC and Dock Controls
ANLG
–39dB
5-5