Restoring Factory Default Settings - JBL AV2 User Manual

®
JBL Performance™ Series AV2 Audio/Video Processor
4. If you touch ALL, the remote will prompt you by displaying
"SURE?" After the SURE prompt is touched, all the buttons will be
erased.
5. If you touch DEVICE, a list of component options are displayed.
Touch the component option that you wish to erase. The bottom
of the screen will flash "ERASE" twice, then "ERASED".
6. If you touch KEY, you'll need to navigate to the component that
you want. Touch a button to erase it. The bottom of the screen will
flash "ERASE" twice, then "ERASED".
7. When finished, exit the Setup mode by pressing the Main button
until the touchscreen displays MAIN in the menu heading area.
The remote control is in normal operation mode again.

RESTORING FACTORY DEFAULT SETTINGS

If you're afraid you've accidently overwritten functions that you
wanted, or want a "clean slate" to start from, the remote control can
be reset to its factory default settings. Follow the instructions below to
restore the factory default settings.
Note: Restoring the Factory Default Settings will ERASE all customized
features, including renamed components, learned buttons and
macros.
1. On the remote control, press and hold the Main and Stop buttons
at the same time. The bottom of the touchscreen flashes
"WARNING!"
NOTE: You now have three seconds to perform the next step. If a
button is not pressed within three seconds, the RESET heading will
revert to MAIN, indicating that the remote control is no longer in
Reset mode. If this occurs, you will need to repeat this step to re-enter
the Reset mode.
2. After about 10 seconds, "RESET" is displayed in the Menu name
section at the top of the LCD touchscreen.
A new screen now displays with three options: ALL, PROG and
EXIT. Touching the EXIT option will leave the menu without
making any changes.
3. Touch the ALL option. The remote will prompt you by displaying
"SURE?" After the SURE prompt is touched, the factory default
settings are restored.
4. When the remote is done restoring the factory default settings, the
menu heading reverts to MAIN. When the touchscreen displays
MAIN in the menu heading area, then the remote control is in
normal operation mode again.
Appendix C
C-13