Advanced Video - JBL AV2 User Manual

Setup
DEFAULT SUR
SETUP INPUT SETUP DEFAULT SUR
Identifies the Default Surround Mode that is activated when a digital
source is selected. The STANDARD parameter activates the
"standard" decoder of the source input. The USE LAST selection
allows the AV2 software to "remember" the last used listening mode
for any given input source. Once selected, that mode is always active
on the corresponding input until another listening mode is selected.
This parameter affects all inputs.
Note: If the LOGIC 7 DEFAULT parameter in the SURROUND CONFIG
menu is set to ON, the USE LAST selection is defeated and the listening
mode will always switch to a Logic 7 mode. For normal functionality with
the USE LAST selection, make sure that the LOGIC 7 DEFAULT parameter
is set to OFF.
A/D SAMPLE RATE
A/D SAMPLE RATE
SETUP INPUT SETUP
The AV2 converts the incoming analog audio signals to digital audio
for all audio processing. The A/D SAMPLE RATE parameter selects the
sample rate of the A/D converters. Some surround processing modes,
such as the DSP Mode family, are only available at a 48kHz sampling
rate. This setting is only available for incoming analog audio streams
and does not apply to any of the ANALOG BYPASS modes.
A/V SYNC DELAY
SETUP INPUT SETUP A/V SYNC DELAY
Delays the audio until it matches the on-screen video. The selected
value activates an audio signal delay to compensate for video that is
delayed relative to the audio. The A/V sync delay range is 0 to 180ms
in 1ms increments. Each input has an independent A/V Sync Delay
parameter. If the JBL BassQ parameter is set to Yes, then the A/V Sync
Delay range is 32 to 180ms.
3-18
STANDARD, USE LAST
48KHZ, 96KHZ
0 TO 180mS

ADVANCED VIDEO

SETUP INPUT SETUP

ADVANCED VIDEO

Selects the ADVANCED VIDEO menu, which provides fine-tuning
adjustments to the video output. For more information, refer to the
next section, "Advanced Video".
Note: Most of the Advanced Video parameters are only available when the
V-Process parameter is set to FAROUDJA.
TRIGGER 2
TRIGGER 2
SETUP INPUT SETUP
Selects the TRIGGER 2 parameter, which configures the Trigger
OUT 2 connector on the rear panel. This trigger output can be
configured independently for each input so that a trigger voltage
signal is sent to the Trigger Out 2 connector when a specific input is
selected. If the Trigger 2 parameter is set to ON, it will output its
voltage when the associated input is activated in the Main Zone. It
is not activated by Zone 2 input switching. The default for the
Trigger 2 parameter is OFF.
ZONE-2 OUT
SETUP INPUT SETUP ZONE-2 OUT
Identifies the type of audio that is sent to the Zone 2 outputs. The
ANALOG setting is a straight bypass of the Main Zone stereo analog
audio to the Zone 2 outputs. DOWN MIX provides a stereo DOWN
MIX of the incoming audio to the Zone 2 outputs. DOWN MIX,
which should be selected for digital or multichannel analog sources,
is only available if the Main Zone has an input selected that will
accept a down-mixed source. The ZONE 2 OUT parameter is NOT
input-specific; a selection made for one input will be reflected in
ALL inputs.
Note: If you have 5.1-channel or 7.1-channel ANALOG AUDIO assigned
to an Input using the BYPASS listening mode, only the Front Left and Front
Harman Consumer Group, Inc.
OFF, ON
ANALOG, DOWN MIX