Fujitsu ScanSnap S300 Operator's Manual page 37

•
Be sure to use the supplied AC adapter and AC cable.
ATTENTION
•
Be sure to use the supplied USB cable.
The operation with any commercially available USB cable is not guaranteed.
•
If only the USB cable is used, the ScanSnap does not operate. Be sure to use
two types of cables, the power and USB cables, to connect the ScanSnap to a
personal computer.
•
Connect the Power cable before connecting the USB cable.
•
Be sure to install ScanSnap Manager before connecting the ScanSnap to your
computer. (For how to install them, refer to section
Programs" on page
•
When connecting to a USB hub, be sure to use the first stage USB hub that is
closest to the computer. If you use the second or later hub stages, the scanner
may not operate properly.
•
When connecting with a USB 2.0 cable, make sure that the USB port to
connect to and hub must be USB 2.0-compliant. Note that if connected with a
USB 1.1 cable, the scanning speed may become slow. When a USB 2.0-
compliant port is available, it is recommended that the USB 2.0-compliant port
be used.
When connecting with the USB bus power cable:
Use the USB bus power cable
Operation
1. Connect the USB bus power cable.
Remove the adhesive label covering the USB and Power connectors.
Connect to the ScanSnap's power connector and a personal computer.
2. Connect the USB cable.
Connect the USB cable to both the ScanSnap and personal computer. Insert until it is all the
way seated in the USB connector and USB port.
USB
connector
Power
connector
3. After power and USB connector are connected with cables, perform the procedure
described in "Turning the ScanSnap ON" on page
2.2 Connecting the ScanSnap to your PC
7.)
and USB cable .
PC
ScanSnap S300 Operator's Guide
"Installing Supplied
USB port
18.
2
17