Connecting The Auxiliary Port To A Modem; Cable; Procedure; Connecting The Fast Ethernet Port To The Fast Ethernet Switch - Cisco VG224 - Analog Phone Gateway Hardware Installation Manual

Chapter 3 Installing the Cisco VG224 Voice Gateway

Connecting the Auxiliary Port to a Modem

Use the procedure in this section to connect the auxiliary port to a modem.

Cable

Use an RJ-45-to-DB25 auxiliary cable (labeled Modem).
For pinouts, see
Specifications and Information."

Procedure

Connect the cable from the auxiliary port (black) to the DB-25 port on the modem. (See item 6 in
Step 1
Figure 3-12 on page
Configure the modem.
Step 2
a.
b.
The baud rate for the auxiliary (and console) port can be configured in software for 1200, 2400, 4800,
Note
19200, 38400, 57600, and 115200.

Connecting the Fast Ethernet Port to the Fast Ethernet Switch

Use the procedure in this section to connect a Fast Ethernet port to the Fast Ethernet switch.
Cable
Use a straight-through Fast Ethernet cable (not included).
Procedure
Connect the cable from a Fast Ethernet port to an available port on the Fast Ethernet switch. (See item
Step 1
4 in
Connect the second cable if it is required.
Step 2
Note
OL-5006-04
Table A-3 on page A-5
3-15.)
Match the transmission speed of the auxiliary port (default is 9600 baud).
Set the hardware flow control for Data Carrier Detect (DCD) and Data Terminal Ready (DTR)
operation.
Figure 3-12 on page 3-15.)
Not all models have two ports.
and Table A-4 on page A-5
Cisco VG224 Voice Gateway Hardware Installation Guide
Connecting Cables
in Appendix A, "Cable
3-17