Wall-Mounting The Chassis; Wall-Mounting The Chassis - Cisco VG224 - Analog Phone Gateway Hardware Installation Manual

Chapter 3 Installing the Cisco VG224 Voice Gateway

Wall-Mounting the Chassis

The following warning applies only when the unit is wall-mounted:
This unit is intended to be mounted on a wall. Please read the wall-mounting instructions carefully
Warning
before beginning installation. Failure to use the correct hardware or to follow the correct procedures
could result in a hazardous situation to people and damage to the system. Statement 248
You can wall-mount the unit with either the right or left side facing up; however, the front and rear panels
Caution
must be vertical.
Note For information about obtaining the chassis guard, refer to field notice number 28655,
Guard - Safety
To wall-mount the chassis, follow this procedure:
Attach the short leg of one bracket to the chassis, as shown in
Step 1
hex screws (provided). Be sure to use a plastic washer (provided) with each screw; the narrow end of the
washer must fit into the bracket slot, facing the chassis.
Be sure to use the correct screws and plastic washers for this mounting option. (See
Caution
page
Figure 3-7
Step 2 Attach the second bracket to the opposite side of the chassis.
Step 3 Attach the router to the wall using the brackets previously attached and attachment hardware that you
provide as follows:
•
•
OL-5006-04
Regulation, at http://www.cisco.com/en/US/ts/fn/200/fn28655.html.
3-6.)
Attaching the Brackets for Wall-Mounting
You can install a starter screw in the wall, and hook the bracket keyhole over the screw. This holds
the unit in place for easy installation of the attachment screws.
Attach both brackets to the wall.
Figure 3-7, using two 6-32 x 1/4 slotted
Cisco VG224 Voice Gateway Hardware Installation Guide

Wall-Mounting the Chassis

VG224 Chassis
Table 3-1 on
3-9