Connecting The Analog Voice Interface To A Distribution Panel; Cable; Procedure - Cisco VG224 - Analog Phone Gateway Hardware Installation Manual

Chapter 3 Installing the Cisco VG224 Voice Gateway

Connecting the Analog Voice Interface to a Distribution Panel

To connect the multiport analog voice interface to a distribution panel, which connects to telephones,
faxes, or analog PBX equipment, use the following procedure. (See

Cable

Use an RJ-21 cable with Amphenol 50-pin connectors (not included).
For RJ-21X/CA21A pinouts, see
Information."
Warning This equipment contains a ring signal generator (ringer), which is a source of hazardous voltage. Do
not touch the RJ-11 (phone) port wires (conductors), the conductors of a cable connected to the RJ-11
port, or the associated circuit-board when the ringer is active. The ringer is activated by an incoming
call. Statement 1042

Procedure

Connect the RJ-21 cable from the analog voice multiport to the distribution panel.
Step 1
Secure the cable in place using the strap.
Step 2
Figure 3-14 Analog Voice Connection
OL-5006-04
Table A-5 on page A-6
VG 22 4- 24
FX S
RJ-21 cable
Cisco VG224 Voice Gateway Hardware Installation Guide
Figure 3-14.)
in Appendix A, "Cable Specifications and
Distribution panel
Connecting Cables
3-19