What You Need To Know; Before You Begin; Unpacking And Inspecting; Mounting The Chassis - Cisco VG310 Installing Manual

Installing the Cisco VG310 and Cisco VG320 Voice Gateways

What You Need to Know

Slot and Port Numbers
Cisco VG310 and Cisco VG320 have built in ports and slots to accommodate modules and interface cards
that include the Enhanced High-Speed WAN Interface Card (EHWIC) and the Packet Voice and Data Module
(PVDM3). For information on slot and port numbering, see

Before You Begin

Read the

Unpacking and Inspecting

Do not unpack the voice gateway until you are ready to install it. If the installation site is not ready, keep the
chassis in its shipping container to prevent accidental damage.
The voice gateway, cables, printed publications, and any optional equipment you ordered might be shipped
in more than one container. When you unpack each shipping container, check the packing list to ensure that
you have received all the following items:
• The Cisco VG310 or Cisco VG320 Analog Voice Gateway
• Power cord, 6 foot (1.8 m)
• RJ-45-to-DB-25 adapter cable (labeled Console)
• RJ-45-to-DB-9 adapter cable (labeled Auxiliary)
• Rack-mounting brackets for 19-inch rack (one pair) with screws for attaching to chassis
• Chassis guard for wall-mounting applications
• Grounding lug and fasteners
Inspect all items for shipping damage. If anything appears damaged, or if you encounter problems when
installing or configuring your system, contact Cisco customer service representative. (See
Assistance.)

Mounting the Chassis

There are three methods of installing the chassis:
•
•
•
Safety Recommendations
Mounting the Chassis on a Rack, on page 6
Mounting the Chassis on a Wall, on page 8
Installing the Voice Gateway on a Bench, on page 10
Interfaces and Service
before installing and connecting Cisco VG310 or Cisco VG320.
Installing the Cisco VG310 and Cisco VG320 Voice Gateways
What You Need to Know
Capabilities.
Obtaining Technical
5