Reset Camera - TRENDnet TV-IP600 User Manual

Reset Camera

A manual reset can be conducted by following the procedure below. The reset button is located on
the rear panel of the camera. To reset the system settings to factory defaults, please follow these
steps:
1. Use a paper clip or similar object to hold down the reset button for three seconds. The reset
button is located on the rear panel of the device. See the Rear Panel Components picture
above to locate the reset button.
2. Release the reset button and the Power LED will begin to flash, indicating that the Camera
is reverting back to factory settings.
Upon restarting the camera loads the factory default configuration settings. The default IP address
192.168.10.30 and subnet mask 255.255.255.0 will be applied unless a DHCP server is actively
connected to the network. If using the TV-IP600W Wireless Camera, the default SSID is
"TRENDNet". The administrator's default user name is admin and the password is admin. Use the
Setup Wizard shipped with the camera to reconfigure it or access it through the web-based
management software.
TV-IP600/W Wireless Network Camera
10