Qos > Qos Setup; Qos Setup - Cisco Linksys RVL200 User Manual

Chapter 4
Service Management
Servce Name
Enter a name.
Protocol
Select the protocol it uses.
Port Range
Enter its range.
Click Add to Lst. Click Save Settngs to save your changes,
or click Cancel Changes to undo them. Click Ext to return
to the Bandwidth Management screen.
If you want to modify a service you have created, select it
and click Update ths servce. Make changes. Click Save
Settngs to save your changes, or click Cancel Changes
to undo them. Click Ext to return to the Bandwidth
Management screen.
If you want to delete a service you have created, select it
and click Delete selected servce. Click Save Settngs
to save your changes, or click Cancel Changes to undo
them. Click Ext to return to the Bandwidth Management
screen.
Drecton Select Upstream for outbound traffic, or select
Downstream for inbound traffic.
Prorty Select Hgh, Mddle, or Low. High priority
services will share 60% of the total system bandwidth,
while Low priority services will share 10% of the total
bandwidth. The default is Mddle.
Enable Select Enable to use this Priority rule.
Click Add to Lst, and configure as many rules as you
would like, up to a maximum of 50. To delete a rule, select
it and click Delete selected applcaton.
Click Summary to see a summary of the Priority rules. The
Summary screen appears.
4-Port SSL/IPSec VPN Router
Advanced Configuration
Summary (Priority Selected)
To change a rule, click Edt. To update the list, click
Refresh. To return to the Bandwidth Management screen,
click Close.
On the Bandwidth Management screen, click Save Settngs
to save your changes, or click Cancel Changes to undo
them.
QoS > QoS Setup
The QoS Setup screen lets you enable QoS and configure
Trust Mode and Class of Service (CoS) settings.
QoS > QoS Setup

QoS Setup

QoS Mode
QoS Mode Select the appropriate mode, Dsable or
Basc. The default is Dsable, which indicates no priority.
If the Basic mode is selected, the Router will apply the
settings configured on the QoS Setup, Queue Settings, and
DSCP Settings screens.
Trust Mode Default CoS
Configure the Trust Mode and Default CoS priority values
for each LAN port.
Port ID
The ID numbers of the Router's four LAN ports are
displayed in this column.
Trust Mode Select the appropriate mode: None, CoS, or
DSCP. The default is None.
8