Chapter 2: Product Overview; Front Panel; Back Panel - Cisco Linksys RVL200 User Manual

Chapter 
Chapter :
Product Overvew

Front Panel

Power (Green) The Power LED lights up green
and stays on while the Router is powered on.
Dag (Orange) The Diag LED lights up when
the Router is not ready for use. During a warm
reset, it flashes slowly. During a reset to factory
defaults, it flashes quickly. The LED turns off
when the Router is ready for use.
Internet
(Green) The Internet LED lights up
and stays on when there is a connection made
through the Internet port. It flashes to indicate
network activity over the Internet port.
Ethernet -4
(Green) These numbered LEDs,
corresponding with the numbered ports on the
Router's back panel, serve two purposes. If the
LED is solidly lit, the Router is connected to a
device through that port. It flashes to indicate
network activity over that port.
4-Port SSL/IPSec VPN Router

Back Panel

Reset
The Reset button can be used in one
of two ways, warm reset and reset to factory
defaults.
Warm Reset
If the Router is having problems
•
connecting to the Internet, press and hold in
the Reset button for four seconds using the
tip of a pen. This is similar to pressing the
power button on your computer to reboot
it. The Diag LED will flash slowly during a
warm reset.
Reset to Factory Defaults
•
experiencing
the Router and have tried all other
troubleshooting measures, press and hold
in the Reset button for ten seconds. This will
restore the factory defaults and clear all of
the Router's custom settings. The Diag LED
will flash quickly during a reset to factory
defaults.
You can also reset the Router to factory
defaults using the System Management >
Factory Defaults screen of the Router's
web-based utility.
Internet
The Internet port is where you will
connect your cable or DSL Internet connection.
Ethernet , , , 4
4) connect the Router to wired computers and
other Ethernet network devices.
Power
The Power port is where you connect
the power adapter.
Product Overview
If you are
extreme problems with
These Ethernet ports (1, 2, 3,