Virtual Passage; Snmp > Global Parameters; Global Parameters - Cisco Linksys RVL200 User Manual

4-port ssl/ipsec vpn router business series
Hide thumbs Also See for Linksys RVL200:
Table of Contents

Advertisement

Chapter 4
SSL VPN > Virtual Passage

Virtual Passage

Client Address Range
Define the range of IP addresses to assign to incoming
Virtual Passage clients. The default is 9.8..00
to 9.8..0. The Router can support up to five
concurrent active users.
Range Start
Enter the starting IP address of the IP address
range.
Range End
Enter the ending IP address of the IP address
range.
Click Save Settngs to save your changes, or click Cancel
Changes to undo them.
SSL VPN Portal
Click Access Portal to connect to the SSL VPN Portal
screen. Then you will be able to establish an SSL VPN tunnel
by Virtual Passage. (For instructions on how to install and
use the Virtual Passage Client, refer to "Appendix B: Virtual
Passage SSL VPN Client. " )
SSL VPN Portal
4-Port SSL/IPSec VPN Router
Advanced Configuration
SNMP > Global Parameters
Configure the parameters to define the SNMP Engine ID
and notification.
SNMP > Global Parameters

Global Parameters

Enable SNMP
To use SNMP, select this option.
SNMPv3
Local Engne ID
If you want to manually generate the
local engine ID, enter the values in text form and then click
Save Settngs. The Router will automatically generate an
engine ID in hexadecimal characters.
Use Default
If you want the Router to generate engine
IDs based on the device MAC address, select this option.
The engine IDs are based on the following:
First Four Octets
First bit = 1
Rest of the bits = IANA Enterprise number (To locate
the IANA Enterprise number, use the show SNMP
command via a command line interface.)
Fifth Octet
Set to 4 to indicate that the engine ID format is text.
Last Twelve Octets
These are the hexadecimal characters of the device MAC
address.
Notifications
SNMP Notfcatons
If you want the Router to send SNMP
notifications, select this option.
Authentcaton Falure Notfcatons
Router to send authentication failure notifications, select
this option.
Click Save Settngs to save your changes, or click Cancel
Changes to undo them.
If you want the
4

Advertisement

Table of Contents
loading

Table of Contents