Table of Contents
Advertisement
♦ If you are using a screen resolution larger than 640 x 480
(standard VGA), the EtherPort Admin display will look best
if you use a "Small Fonts" setting.
♦ You need to have the IPX network protocol and the Novell
NetWare client services enabled. EtherPort Admin uses the
IPX protocol for communicating with the print server.
You only need to have one workstation that meets the above
requirements. It is not necessary to run the EtherPort Admin
program on every workstation. Ordinary network stations will still
be able to print to your TE100-PS3 print server.
If you will only be using TCP/IP (U
protocols, you can use the
Windows-based EtherPort Admin. For more information about
using the
Administration section on page 111.
Installing EtherPort Admin
Follow the procedure outlined below to install EtherPort Admin:
1. Insert EtherPort Admin installation disk 1 into your system's
3.5" floppy drive (A: or B:).
2. If you are using Windows 3.1x or Windows NT 3.51, choose
Run... from the Program Manager's File menu. Under
Windows 95/Windows NT 4.x or later Windows-based
operating systems, choose Run... from the Start menu on
the taskbar. When the dialog box appears, type the
pathname of the Setup program on the floppy drive
(
A:\SETUP
Installing and Starting the EtherPort Admin Program
telnet
interface, see the Appendix: Telnet Interface
telnet
or
) and click OK.
B:\SETUP
Print Server Administration User's Guide
) and/or AppleTalk
NIX
interface instead of the
9
Advertisement
Table of Contents
