Setting The Receive Mode; Receiving Faxes And Phone Calls Automatically: Faxtel Mode; Setting The Options For Faxtel Mode - Canon FaxPhone L170 Basic Manual

Setting the Receive Mode

Set the machine receive mode as follows:
1
Open One-Touch Speed Dial panel © press [Receive Mode].
The LCD display shows the current receive mode setting.
2
If you want to change the receive mode, press [Receive Mode] repeatedly until the mode you want appears © press [Set].
Each time you press [Receive Mode], the receive mode changes in the following order:
FaxOnly © DRPD © Manual © AnsMode © FaxTel © FaxOnly © ...
Receiving Faxes and Phone Calls Automatically:
FaxTel Mode
Set this mode if you want your machine to automatically switch between voice and fax calls.
You can control precisely how your machine handles incoming calls by adjusting the settings below.
7

Setting the Options for FaxTel Mode

I RING START TIME
When a call comes in, the machine checks to see if it is a person wishing to speak to you or a fax machine trying to send a document. If
your machine does not have enough time to detect the fax tone, it assumes the call is from a telephone. Use the <RING START TIME>
setting to increase the time the machine takes to check whether a call is from a fax machine or a telephone. You can select a time between
0 and 30 seconds; the default is 6 seconds.
I F/T RING TIME
When your machine is set to receive both fax and telephone calls automatically, the telephone rings to alert you to pick up the handset if the
call is from a person. If you do not pick up the handset within a certain amount of time, the telephone stops ringing. Use this option to
change the number of times the machine rings, from 15 to 300 seconds. The default is 15 seconds.
I F/T SWITCH ACTION
Not all fax machines are capable of sending a fax tone (the CNG tone that warns the receiving fax machine that a fax is coming). For those
cases the machine may think that the call coming in is a voice call and rings to alert you of the call (the amount of time it is going to ring is
determined by the <F/T RING TIME> setting above). If you do not answer the call, one of two things can happen:
1. If you set the <F/T SWITCH ACTION> to 'RECEIVE', the machine will switch to fax receive mode automatically at that point and start to
receive the document. If no document comes in, it disconnects the call after approx. 40 seconds. The factory default setting is
'RECEIVE'.
2. If you set the <F/T SWITCH ACTION> to 'DISCONNECT', the machine will disconnect the phone call immediately freeing up your phone
line at this point.
7-2 Different Ways to Receive a Fax