Brother PT-3600 User Manual page 97

Problem
(4) The P-touch is not working correctly.
(5) The machine has "locked up" (i.e., noth-
ing happens when a key is pressed).
(6) The half cut is either too deep or not deep
enough.
Solution
G Reset the P-touch by turning it off, then
while holding down d and R, turning
the machine back on.
All settings will be reset to their defaults
and the entire contents of the memory will
be cleared. If it necessary to keep the cur-
rent settings and stored files, back them up
to the computer using the P-touch Backup
Manager.
Before installing or removing the tape cas-
sette, be sure that the P-touch has been
reset.
G Reset the machine by:
- (PT-3600) unplugging the AC adaptor,
and leaving it unplugged for about one
minute, then and plugging it in again
- (PT-9600 only) pressing the reset button
in the battery compartment at the bottom
of the machine
The text and formats in the display and all
text files stored in the memory will be
erased.
Before installing or removing the tape cas-
sette, be sure that the P-touch has been
reset.
G
Follow the procedure on pages 76 to
adjust how deep laminated tape is cut.
TROUBLESHOOTING
85