Brother PT-3600 User Manual page 32

Ch. 2 Getting Started
6 Double-click the P-touch Editor 3.2 Installer icon
in the folder that appears. The installer starts up,
and then the Introduction dialog box appears.
NOTE
When the Next button is pressed, a message may
appear, warning that an older version of the software
is installed. Be sure to uninstall the older version of the
software before trying to install the new software. For
details on uninstalling the software, refer to To unin-
stall the P-touch Editor 3.2 software: on page 32.
7 Click the Next button. The Choose Product
Components dialog box appears.
8 Select the installation method.
G For a typical installation
Click the Next button to immediately start
installing all options.
NOTE
About 20 MB of available hard-disk space is needed to
begin installation. In order to install all options, about
100 MB of available hard-disk space is needed.
G For a minimal installation
Select "Minimal" from the Feature Set list,
and then click the Next button to start install-
ing just the P-touch Editor 3.2 application.
20
NOTE
If certain options (such as the Auto Format Tem-
plates and the Clip Art) are not installed, some P-
touch Editor functions may not be available.
G For a custom installation
Select "Custom" from the Feature Set list
to display the list of options that can be
selected for installation.
Only the options with a check mark
beside them are installed. Select the
options that you wish to install, and then
click the Next button.
The Choose Alias Folder dialog box
appears, allowing you to select where an
alias to P-touch Editor 3.2 will be added.
9 Select the desired location for the alias, and
then click the Next button. A dialog box
appears, allowing you to check the installation.