Brother PT-3600 User Manual page 26

Ch. 2 Getting Started
7 Select the desired locations for the short-
cuts, and then click the Next button. A dia-
log box appears, allowing you to select
whether or not to install the printer driver.
To install the printer driver, click the Yes
button. The first Driver Setup dialog box
appears, allowing you to select whether the
P-touch will be connected through the USB
port or the RS-232C port.
Continue with the procedure in Installing
the USB printer driver on page 14. (To
install the serial printer driver, refer to the
Advanced Functions booklet.)
NOTE
If the printer driver is already installed, click the No
button. A dialog box appears explaining that instal-
lation is finished. Select "Yes, I want to restart my
computer now.", click the Finish button to restart
the computer, and then remove the CD-ROM from
the CD-ROM drive.
Installing the USB printer driver
With Plug-and-Play, new devices connected to
the system are detected, and their drivers are
automatically installed. If the P-touch 9600/
3600 is to be connected through the USB port,
its driver will be installed with Plug-and-Play.
Be sure to read the installation instructions
described below before installing the printer
driver supplied on the CD-ROM.
NOTE
Do not connect the P-touch to the computer
until you are instructed to do so, otherwise the
printer driver may not be installed correctly.
The dialog boxes shown in the procedures
below are for the installation of the software for
the PT-9600. When installing the software for
the PT-3600, the dialog boxes may be slightly
different from those shown.
14
To install the USB printer driver
®
With Windows 98, 98 SE, Me or 2000:
1 In the dialog box that appears, allowing you
to select whether the P-touch will be con-
nected with a USB cable or an RS-232C
cable, select "USB cable", and then click
the OK button. A dialog box appears,
informing you that the PT-9600/3600
printer driver will be installed.
2 Click the Next button. A dialog box
appears, instructing you to connect the P-
touch to the computer.
3 Connect the P-touch to the computer using
the enclosed USB interface cable as
described on page 9, and then turn on the
P-touch. A dialog box appears, indicating
that the printer driver has been installed.