Table of Contents
Advertisement
Lamp information
Getting to know the lamp hour
When the projector is in operation, the duration (in hours) of lamp usage is automatically
calculated by the built-in timer. The method of calculating the equivalent lamp hour is as
follows:
See
"Setting Lamp mode as Economic"
To obtain the lamp hour information:
1.
Press Menu/Exit and then press
highlighted.
2.
Press
to highlight Lamp Settings and press MODE/ENTER. The Lamp Settings page
displays.
3.
You will see the Equivalent lamp hour information displaying on the menu.
4.
To leave the menu, press Menu/Exit.
You can also get the lamp hour information on the INFORMATION menu.
Extending lamp life
The projection lamp is a consumable item . To keep the lamp life as long as possible, you can
do the following settings via the OSD menu.
Setting Lamp mode as Economic
Using Economic mode reduces system noise and power consumption by 20%. If the
Economic mode is selected, the light output will be reduced and result in darker projected
pictures.
Setting the projector in Economic mode also extends the lamp operation life. To set
Economic mode, go into the SYSTEM SETUP: Advanced > Lamp Settings > Lamp mode
menu and press
Setting Auto Power Off
This function allows the projector to turn off automatically if no input source is detected
after a set period of time to prevent unnecessary waste of lamp life.
To set Auto Power Off, go into the SYSTEM SETUP: Basic > Operating Settings > Auto
Power Off menu and press
minute increments. If the preset time lengths are not suitable for your presentation, select
Disable. The projector will not automatically shut down in a certain time period.
below for more information on Economic mode.
/
/
.
/
. The time period can be set from 5 to 30 minutes in 5-
until the SYSTEM SETUP: Advanced menu is
Maintenance
53
Hide quick links:
Advertisement
Table of Contents
