Timing Of Replacing The Lamp - BenQ W1060 User Manual

Timing of replacing the lamp

When the Lamp indicator lights up red or a message appears suggesting it is time to replace
the lamp, please install a new lamp or consult your dealer. An old lamp may cause a
malfunction in the projector and in some instances the lamp may explode.
The Lamp indicator light and Temperature warning light will light up if the lamp becomes too
hot. See "Indicators" on page 58
The warning messages below are for reference only. Please follow the actual on-screen
instructions to prepare and replace the lamp.
Status
Install a new lamp for optimal performance. If the
projector is normally run with Economic selected
(See "Setting Lamp mode as Economic" on page
53), you may continue to operate the projector
until the next lamp warning appears.
A new lamp should be fitted to avoid the
inconvenience when the projector runs out of
lamp time.
It is strongly recommended that you replace the
lamp at this stage. The lamp is a consumable item.
The lamp brightness diminishes with use. This is
normal lamp behavior. You can replace the lamp
whenever you notice that the brightness level has
significantly diminished.
The lamp MUST be replaced before the projector
will operate normally.
"XXXX" shown in the above messages are numbers that vary depending on different models.
54 Maintenance
for details.
Message
Notice
Notice
Notice
Notice
Order Replacement Lamp
Lamp > XXXX Hours
Order a new lamp at lamp.benq.com
OK
Replace Lamp soon
Lamp > XXXX Hours
Order a new lamp at lamp.benq.com
OK
Replace Lamp Now
Lamp > XXXX Hours
Lamp usage time exceeded
Order a new lamp at lamp.benq.com
OK
Out of Lamp Usage Time
Replace lamp (Refer to user manual)
Then reset lamp timer
Order a new lamp at lamp.benq.com
OK