Station Control - Alvarion BreezeNET PRO.11 Series User Manual

Using the Local Terminal for Unit Setup and Management
Broadcast Relaying (AP Only) – Whether the unit performs broadcast
relaying. When Broadcast Relaying is enabled, Broadcast packets originating
in WLAN devices are transmitted by the AP back to the WLAN devices, as
well as to the LAN. If it is disabled, these packets are sent only to the local
wired LAN and are not sent back to the WLAN. Disable Broadcast Relaying
only if you know that all Broadcast messages from the WLAN will be destined
to the wired LAN.
Unicast Relaying – Whether the unit performs Unicast relaying. When
Unicast Relaying is enabled, Unicast packets originating in WLAN devices
can be transmitted back to the WLAN devices. If this parameter is disabled,
these packets are not sent to the WLAN even if they are intended for devices
on the WLAN. Disable Unicast Relaying only if you know that all Unicast
messages from the WLAN will be destined to the local wired LAN.

3.4.5 Station Control

The Station Control menu contains the following options:
Reset Unit – Type 1 to reset the BreezeNET PRO.11 unit and apply any
changes made to the system parameters.
Load Defaults – When this option is implemented, system parameters revert
back to the original factory default settings. There are two options:
User's Guide
Load Full Factory Defaults – All parameters revert to defaults except
for Japan Call Sign (if applicable) and Hopping Standard.
Load Partial – All parameters revert to defaults, except for Japan Call
Sign (if applicable), IP Address, Subnet Mask, Default Gateway, Hopping
Sequence, Hopping Set, ESSID, Transmit Diversity, Long Range,
Preferred AP, IP Filtering, Hopping Standard, Power Level, Auto
Calibration, Encapsulation, WEP Attributes, Authentication Algorithm,
Pre-authentication, WEP Default Keys, Ethernet Disable, Trap Host
Addresses.
3-12
BreezeNET PRO.11 Series